Any Article Re-writing Software is the Best?

[Hafiz Zo]

Hi Warriors...


Need some help.

I am looking for a software or membership site so that i can re-write my articles and probably spin it too.


I want to generate the most no. of unique articles in the less time possible.


Anybody care to give a recommendation please...


Thank you Warrior...!

[RebeccaL]

Good idea if you want junk articles.

Bad idea if you want quality content.

I prefer the latter. Therefore I have no recommendation.

[mikemcmillan]

This is only my opinion, and most here would disagree, but I would never re-write or spin one of my articles. I take too much pride in what I do and I want people who read one of my articles to come back and read others.

I'm sure most articles directories aren't too keen on article spinning either. If you get to much junk from a directory you are less likely to go back there and find other articles.

Not trying to sound holier than thou at all. But that's my take on article spinning. Look at it this way. If you were going in for brain surgery, would you rather go to a doctor who read an original copy of a book on the topic of brain surgery, or--one who read a book on the topic that had been put through some kind of spinning software?

Tons of people spin articles. I know that--it's just not my cup of tea.

[JohnPark]

If you practice enough, you could write good quality articles in little time. There is so much content out there that you can get ideas from. You shouldn't have to sell yourself short with a spinner. Give people something to remember you by. You may as well start now, because Google is cleaning up the net. Only good, quality content will survive.

[timpears]

Unless you know WHY a person wants to spin articles, I don't think it is right to respond the way you have in the prior posts. The OP asked for a reference for a specific item. It is up to him why he wants it and what he does. Your responses may be very true, but they were not a response to his request.

That being said, I would give you a link but it is to a thread in the War Room and I see you are not a member. So I would check with a member k60mall who has some services that you can join and one of them provides article spinning. I looked over his site and found it very interesting. I have not used the service so I can not give you any recommen. but he has an article that you can spin on his web page. I don't know how much faith you can put in that, so you will have to make your own decision. But check with the person and get his web site address and see if what he has can provide what you are looking for.

Hope this can be of some help to you. Good luck.

[AM Faisal]

all those rewriting sofwares out there not good
its better to write the articles yourself..with some practise you can increase your speed

[banless]

I agree with others, if you need to rewrite articles then this shows a sign of desperation and lack of originality. And neither will help you in the search engines if that is what you are trying to do. If you need articles then why not just get in contact with a company that can write new and fresh articles for you? I don't use these type of services so I will not point you to any kind of reference, but If I needed the articles that is the route I would take.

[Alican Yenidogan]

I don't agree with ANYONE posted above.

Here is WHY:

If you spend 30 minutes on an article (which is the time required to write a very good article - this includes researching the niche), I guarantee you that you'll get 100-1000 VERY GOOD QUALITY articles from MOST OF THE ARTICLE SPINNERS.

What you basically do in a spinner is, you select the word(s) or sentences and enter synonyms or sentences that mean the same thing. So instead of saying:

I go to school from work at 5 pm

you may say

I leave work for school at 17:00.

BUT (a very big BUT here)

If you don't take the time required and just let the article spinner do all the work (like some kind of magic which doesn't exist), you will have garbage like the rest have written.

Just take the time to know the software you are using, experiment with it and the result will be VERY VERY GOOD!

Alican

[brucekaushik]

so guys after all that you have said any software or website recommendations yet??

because i too am waiting for them ..

actually my need is to write an article as much as possible (i am not spinning here but writing from scratch) but i want to earn more money so want to complete them fast

i write all kinds of articles and most of them are creative so no spinners or runners used there because it will take time to think or present a thought. But for articles on specific niche i can do it better with any software that good enough.

anyways .. here is what i know .. there is a software called dragon naturally speaking but its not a rewriter or spinner but its a speech recognition software and i herd that its too good .. you can speak into it and you get the words exactly without having to type .. its a bit costly so i did not buy it yet but i am going to get right after i start making some decent money.

[AndyBlackSEO]

Spinning software can be effective if you spend the initial time required to set it up. Depending how much time you spend on this will change the level and quality of your articles. In the long run you can save a lot of time and effort.

I would say, if you are wanting to create content for any ONE website then don't use a spinner. Either write them yourself or use a rewriting tool to help with the writing / rewriting process. If you are wanting to write articles for distributing to article directories etc, then use a spinner. Particularly for backlinks.

As for recommendations. Seeing as though I can't plug my own article creator here, then magic article rewriter and magic article submitter are quite good. You can buy them as a bundle for $80.

There are others though which all work differently to some degree.

All I would say though is if you do you one of these tools, spend the time to set it up right AND well. Rush this process and you'll be wasting your time. That's what I advise my members.

[dean7227]

IMHO, no matter what software you're using to spin the articles, you still need to proof read and make certain adjustment to the article as it might still have some grammartical and syntax error.

[David Mcalorum]

Screw article rewriting software dude.

With my experience, (I have had a LOT)
all of them actually suck.

Just rewrite them yourself or outsource someone else to
rewrite them for you.

Cheers.

[tamsintwo]

Whilst I agree with the concensus that writing the articles yourself is the best way to go, for those of us who haven't ever written articles, it's difficult to know where to start and can therefore be very time consuming, and, as one poster pointed out, if you take the time to proof read the spun article, it can't possibly take any longer than having to write the whole thing from scratch. I'm referring to LOTS of articles, not quality content for your niche site.

I'm also very new to this, but can spot a spun article straight away. The 'spinner' just didn't take the time to proof read.

So only the two recommends then?

[Brandon Tanner]

I would never use a word processor like Microsoft Word or OpenOffice to write my content. Everyone knows that all word processors produce garbage!

If an article or ebook sucks, it's not the writer's fault. Surely it's because they used one of those newfangled word processors like Microsoft Word or OpenOffice, instead of writing it out by hand with a pen and pad!!!

Oh wait a sec, this thread is not about article writing? It's about article rewriting?? As in writing an article again? Oops, my bad.

[andrew_writes]

Originally Posted by Hafiz Zo

Hi Warriors...


Need some help.

I am looking for a software or membership site so that i can re-write my articles and probably spin it too.


I want to generate the most no. of unique articles in the less time possible.


Anybody care to give a recommendation please...


Thank you Warrior...!

Mass Article Creator.

it can take a lot of time on the front end because the more you do the better you will get.

Once the front work is done, the spinning is great and you can get about 800 good articles at least 30% and more diff from each other.

[Sirago]

I don't think spinning articles is a bad idea but you need to take the time to write a decent article and then take the time to do a decent job spinning it. Nothing automatic - actually sit down and spin it manually and make sure it all makes sense.

[Lady_T]

I've never tried to spin an article, but
when I'm rewriting my own articles to
submit to article directories I use
a free program called WordFlood.

I like it because it gives you a ton
of synonyms to use when you click
on a word you'd like to change.

My articles end up being completely
unique and it's been real helpful.

Sorry, I don't know anything about
spinning, but you can certainly use
this software to rewrite your articles.

It's free to use so if you don't like
it, you haven't lost one dime.

[DAS_Matt]

Originally Posted by andrew_writes

Mass Article Creator.

it can take a lot of time on the front end because the more you do the better you will get.

Once the front work is done, the spinning is great and you can get about 800 good articles at least 30% and more diff from each other.

Originally Posted by Lady_T

I've never tried to spin an article, but
when I'm rewriting my own articles to
submit to article directories I use
a free program called WordFlood.

I like it because it gives you a ton
of synonyms to use when you click
on a word you'd like to change.

My articles end up being completely
unique and it's been real helpful.

Sorry, I don't know anything about
spinning, but you can certainly use
this software to rewrite your articles.

It's free to use so if you don't like
it, you haven't lost one dime.

Nice to see people actually answer the question asked. I've heard wonderful things about both of these.

[damongreene]

I have a few good spinners I have used. If you want my suggestions PM me... However There are several free web based spinners I use. If you do spin an article (for whatever reason) you want a manual spinner that you physically have to supply the rewrite options.

If you you use the automated spinners that use synonyms to replace common words you are bound to get CRAP. You MUST add the human element. It will typically take between 30 minutes and 60 minutes to rewrite a good article well. I like to make each article 25% - 35% different and Ill get at least 25+ variations.

[timpears]

Ok, I am going to try this again. Evidently I didn't do a very good job in my previous post. Check a member who goes by the handle k60mal. If you click this link >View Profile: k60mall you will get his profile. There are a number of links in his signature that may help as he does article spinning in some of them. I think the first link in his signature is probably the one that you are looking for, and he seems to have very decent prices.

He has a very interesting thread in the War Room if you are interested. Wich is where I found him. I know that I am considering using his service to spin articles for back link building. But check out his post in the War Room at http://www.warriorforum.com/war-room...ing-pages.html

[lindadougherty]

Jet spinner, mass article creation are some tools that can spin your articles. But I would not recommend it, instead I suggest that you it your self or have some to outsource ans rewrite articles for you.

[Jon Alexander]

Autojetspinner.com - Automatic Jet Spinner Software to rewrite your articles instantly can turn ordinary text into jet spinner syntax automatically.

For example,

"I don't think spinning articles is a bad idea but you need to take the time to write a decent article and then take the time to do a decent job spinning it. Nothing automatic - actually sit down and spin it manually and make sure it all makes sense. "

becomes

"I do{ not believe|n't think|n't believe} spinning articles is a {really|very} bad {idea|concept|plan} but you {need|want} to {bother|take some time|take the time} to {scribble|write|draft} a {respectable|good|decent} article and then {bother|take some time|take the time} to do a {decent|respectable|good} job spinning it. Nothing automat{ic|ed} - {actu|essenti|basic}ally sit down and spin it {manually|by hand} and {confirm|make sure|ensure} it all {makes sense|seems sensible|sounds right}."

which allows you to generate over 400,000 variations on that one simple paragraph such as:-


"I do not believe spinning articles is a very bad idea but you want to make the effort to draft a good article and then take some time to do a respectable job spinning it. Nothing automated - basically sit down and spin it by hand and ensure it all sounds right."

[sanjid112]

SpinProfit, simple-free-article-spinner.
find it through Google.

but, don't depend on it 100% and you know why....

-Malik

[ebizman87]

Originally Posted by timpears

Unless you know WHY a person wants to spin articles, I don't think it is right to respond the way you have in the prior posts. The OP asked for a reference for a specific item. It is up to him why he wants it and what he does. Your responses may be very true, but they were not a response to his request.

Hope this can be of some help to you. Good luck.

Exactly what I wanted to say just now.

[Ray Erdmann]

Power Article Rewriter - If you can find the link, you can pick it up for under $40 dollars. You can get a 15 day trial of the app here:
Power Article Rewriter

Another version VERY, VERY SIMILAR to Power Article Rewriter is simply called "Article Rewriter" - You can get a full functional 30-day trial here:
Article ReWriter - Article ReWriter Trial

If you like this version, send me a PM and I'll give you some useful information regarding it.

Hope this helps!


Ray